Doing it like I do makes you very aware of the cutter spinning away and you tend to be extra careful, I think sticking a bigger piece to the likes of ...

@tv101 you don't do that, if it wants to go it goes! Never push into the cutter.

@rathius wooden covers, often to match the top. That router is set on 4 out of 6. No idea what the actual speed is. This one has an oak top, I ...

@rathius Yeh bud, great for cavity covers etc.

Well I would say yes to a recess, looks great and allows loads of travel in both directions. I think the gotoh floyds are about 11mm overall so I aime...

@robin we won't hold it against you lol

@swepri me three but they've always been A for audio and B for linear. No idea where anyone buys the back to front crazy pots lol

@tv101 excuse me, I'd like to buy some pots off you, could you send them out so I can test them before paying? Thanks 🤣

@koendb can't fight nature lol

@koendb always the same, you go to bed then wake up to another change in what you know to further complicate your life 🤣

@robin I've got to ask, where did you find these weirdo pots? 🤣 I generally stick with alpha and cts for the most part as I can get both in met...

@swepri every pot for guitar I ever see is either china, japan or usa made anyway, can't say I've ever seen a european pot. Seen reference to vintage ...

@robin how sure are you? It's how they sound that I notice them. Audio taper sounds gradual, Linear sounds like a switch lol. Every A and B pot I've u...

@swepri never seen that yet, I've used all sorts and every A has been audio taper and every B has been linear. Are you sure about the US Euro thing?

@tv101 meh, worst case I'll make a new neck, I like making them lol

@tv101 do you believe carbon rods actually do anything? That somehow they'll stop a neck from twisting if it wants to? Personally I think it's a fad t...

Yeh what Mark says, I do all the routing while the body is flat then carve after. Whether actual carve top or just doing arm and belly carves.

If the neck is parallel, the bottom of the fretboard is usually about 2mm or so higher than the top of the body. With this one I wanted the fretboard ...

Just buy 10mm acrylic off ebay and make a bigger base, works great. I've done both my trim routers and one I can clamp upside down for doing small job...

@tej Ash makes a beautiful neck, done a few myself with zero issues but I always do a volute which may or may not help. Northern/european ash. It's th...