I tested it and had a problem with the kill switch button, it was working but inconsistently. After an inspection I realised that I had melted the switch with the soldering iron and one of the terminals had come out. I ended up swapping the switch for another, but a black metal one, it still look slick. 🖤💛
Make guitars, not war 🌍✌️🎸
I also installed the strap buttons and locks. I took advice from @mattbeels and drilled the hole on the bottom end of the guitar (for the strap button) a little higher from the centre line. This is so the guitar will balance a bit better when on its strap and you are stood up playing.
Cheers Matt, I hope you are doing good. 🤘😜🎸
Make guitars, not war 🌍✌️🎸
Oh and one last thing to add (I’ll do it tomorrow), I thought I would install some of these bright yellow strings for my customer. It will add to his vision of a matt black guitar (nitro) with black chrome hardware with little highlights of yellow. I think I’ve managed it, I just need to box it up and ship it to him. 🖤🎸💛
I’ll show a couple more pictures tomorrow when I’ve installed these cool strings.
Make guitars, not war 🌍✌️🎸
@clinton Hey Clinton, can I ask you about building a baritone version of this guitar, someone has expressed an interest.
If I remember rightly, you made a baritone and a bass version.
This guy wants a 27” baritone. My question is, did you make a longer neck heal to give it more strength? Is there anything else I should do differently? Maybe @markbailey could weigh in too.
Thanks very much in advance. 👍
Make guitars, not war 🌍✌️🎸
@boo Hi never made a baritone before. I made a 32 inch scale lenght bass bandsman and used a 23 11/16 inch truss rod that just made it spot on for a 24 fret with a standard neck heel for the fretboard. For a a Baritone an 18 inch truss rod will work if the adjustment access is at the heel of the neck. Otherwise Bitterroot truss rods make a 20 1/8 inch specifically for 27inch scale lenght baritone guitars.