Nominal routing depth for neck pockets for fender style bridges with 21-22mm thick neck blanks, 5-6mm fretboards. Start off at 16mm neck pocket route ...

Here is a tip. When in doubt we are here for you. Correction In the video I said 22mm thickness on my neck blank but it is actually 24.5mm.

@kalimar If the piece is long enough, you can cut off a piece to glue to thicken headstock or do a scarf joint. It is done all the time.

@kalimar surely can. With P-90s you are gonna need a smaller diameter flush trim bit and with fender style bridge, no neck break angle but completely ...

@jamesbisset The cutaway is not quite cut yet. Major but Minor adjustment it seems like and it is your only recourse with a slight adjusting of the hu...

Laminated Koa Bodies

Neck pocket templates

Welcome to the builds. It does not disappoint. It is very gratifying!

Short Scales

Surely can do. Steam, a radius dish and go bar clamping would make your life so much easier.

Welcome to the builds. Savor the journey and enjoy the outcome.

Looks like a Tele in the making with a B bender. Woohaaa!! Hint hint!

@rocknroller912 best solution I feel would be a vacuum press for sure. In the past and I did it only once and came out satisfactory. With more thou...

@rocknroller912 Maple carve top

@timc I shortened my neck screws before and for some reason decided to cut it on a slight angle as opposed just straight flat. In fear that it will ...

Bursting The Sun

I coat all my MDF templates with lacquer or sanding sealer. Prevents damage from double sided tape.

30 inch scale length