I use this one frequently. Recommended

thanks @cheesewhisk!

@tej: Workshop Weekend Sunday Special !! Building a guitar at home - Making a Thru Neck Guitar

@tej. you could do with relief cuts, or what I have done with , for example, my Flying V, is to use the offcuts pieces to give the clamps a flat surfa...

@Tej I don't know yet. This would be my 3th scratch build and first one with a neck through.This process is still in development in my mind. I have so...

Yes it is really quiet the last couple of weeks. I guess life is catching up again 🙂

@powerful it is at least worth the experiment!

V2: Correct Bridge and angle slightly lowered into middle section V3: Hump in bottom half of the body slightly removed V1, V2 or V3 ? 🙂

The bridge is already decided and I have it in my drawer :-)I just need to alter the plan

AS a matter of fact, I did. But You do have a point though, if you look on the original drawing, the angle starts more towards the centerpoint, where ...

@Tej thx for the comments! Actually that angle was done on purpose. 😀 One thing I am not sure about is the amount of mass I have behind the bridge (...

This is what I came up with reshaping an existing plan

Welcome @powerful !

@hudsoncustoms Welcome!

24.75" scale length is indeed easier for bending. Same strings feel less stiff then a 25.5" scale length. I guess 25" is a good compromise and prob...

@frank1985 It is the flat metal part that needs to face up.

@steveadams I think that rescue looks really good! I agree with @bpower and @rocknroller912.

Watching this! I am also thinking about a neck tru as my next project!