Finished at last, well ish lol. Found a high fret I missed, I often miss just the one. Anyway sorted that, still need to lower the nut a little too. O...

@nortski Use the @ symbol or hit reply on their post Problems with the form could be somehting like an adblocker, if using one try switching...

I always seem to get through using the contact us form on the shop, I think it's Carol that usually replies.

@liebe I was concerned about slot depth, slots being clean, getting to much glue on and it choking the slots etc etc lol Might try the acetone next ...

@liebe For sure, without it you can use a regular fret saw lol What glue did you use? I found out the hard way that wood glue doesn't work with ...

Well it's taken a while but the finish is done at least. I'll get it all assembled in the next day or two. Thanks to this forum I found an old post ab...

Frets are in and side dots done, next up will be sorting the headstock and carving the neck.

@liebe I got one of those hosco fret slot cleaning saws, seems to work ok

@wolframmalukker sounds like you need to clear some space, I'd try and just focus on one, get it over the finish line then the next and so on. I find ...

While the finishing of the bass takes ages due to the weather I decided to get on with the tele build. I've roughed out the neck and today was radiusi...

Looking good Brian! But my advice, don't rush the finish or it'll take longer lol

Looks good @Boo!

@nortski I think it's just the way he builds guitars, there's also a lot of info to try and make into a course so bound to be the odd thing here and t...

Started the finishing

@nortski I think there's a bit of confusion here, basically if you look at say a les paul or prs they have the nut at the end of the fretboard. I thin...

Got the comfort carves done today. I had a go with the grinder and sanding disc on the arm carve but gave that up and went back to good old hand tools...

@steveh well I can blame it on age at least lol

@steveh I place the claw against the back of the spring cavity and move it about until I'm happy it's centred then go round in the holes with a pencil...

Today was a little tidy here and there and then onto bridge fitting, pickup routing, control cavity and wire holes. I set the depth stop on my drill p...

Today I smoothed out the back and front and did the neck heel transition area.